-
Single Phase 5kV EFT/Burst GeneratorEFT/burst generator or transient generator or voltage spike generator is used for evaluating the performance of electrical and electronic equipment power supply, signal, control & earth ports when
-
Three Phase 5kV EFT/Burst GeneratorSwitching the transient process (to cut off inductive load, relay contact bounce, etc.) usually interferes with other electrical and electronic equipment in the same circuit. This type of
-
ESD Test BenchESD1700 ESD (electrostatic discharge) test set-up is for table-top/floor-standing equipment laboratory tests (ESD immunity test environment configuration), which is designed as per standard IEC/EN
-
Capacitive Coupling ClampEFT 4C capacitive coupling clamp is used together with EFT/burst generator. It is used to do EFT/burst interference test of the I/O data signal line port. Its main purpose is coupling the EFT/burst
-
Data Line Coupling NetworksCDN-I/O, CDN-I/OE are designed for communication/telecom products and other signal lines coupling/decoupling surge test network. It can be tested in single, double(1-pair), four(2-pair) and eight
-
SPD Surge GeneratorLightning surge generators SOSIN 2/10, SUR 1000, SUR 360 and other products are anti-surge test products designed specifically for anti-surge protection and other semiconductor devices and
-
Single Phase 10A Voltage Dips GeneratorVoltage dips/sags, short interruptions are caused by failures of the power grid and power facilities or sudden large changes in loads. In some cases, there will be two or more consecutive dips or
-
Impulse Magnetic Field Generator PFM S9Impulse Magnetic Field Generator PFM S9 can meet the requirements of standard IEC 61000-4-9 and GB/T 17626.9. Impulse magnetic fields are generated by lightning strikes on buildings and other
-
Ring Wave GeneratorRing wave is caused by power supply and control line switches or lightning strike and appears on the terminal of devices. The ring wave may affect the reliable operation of equipment and system.A
-
Single Phase 6kV EFT/Burst GeneratorEFT/burst generator or transient generator or voltage spike generator is used for evaluating the performance of electrical and electronic equipment power supply, signal, control & earth ports when
-
Three Phase 6kV EFT/Burst GeneratorSwitching the transient process (to cut off inductive load, relay contact bounce, etc.) usually interferes with other electrical and electronic equipment in the same circuit. This type of
-
Ring Wave Generator RWI S6A ring wave generator is used to evaluate the performance of electrical and electronic equipment, devices or systems subjected to ring wave. Ring wave is caused by power supply and control line
immunity to such failure must be demonstrated by realistic tests which validate the design rules and installation practices of the equipment. However, a balance must be found between overdesign and...
The EFT61000-4 EFT immunity tester is specially designed according to the characteristics and requirements of EFT measurement and it is an ideal disturbance source of EMS measurement. It has fine...
The EFT waveform, as defined by the IEC 61000-4-4 standard, is intended to be used by manufacturers to test the performance of equipment when subjected to fast transients....
In the EFT immunity test the generator creates a sequence of low-energy pulses known as a burst. Each pulse has a rise time of 5ns and a pulse duration of arou nd 50ns (time-to-half value). The burst...
EFT pre-compliance immunity test EFT stands for electrical fast transient is caused by switching the inductive loads like motors, switches, and relays. A burst generator is used to simulate the...
EFT testing is typically performed on AC or DC power ports, and on signal/control ports which may be connected to cables greater than 3m in length. Contact Com-Power Corporation for All Your Testing...
