-
Capacitive Coupling ClampEFT 4C capacitive coupling clamp is used together with EFT/burst generator. It is used to do EFT/burst interference test of the I/O data signal line port. Its main purpose is coupling the EFT/burst
-
Single Phase 5kV EFT/Burst GeneratorEFT/burst generator or transient generator or voltage spike generator is used for evaluating the performance of electrical and electronic equipment power supply, signal, control & earth ports when
-
Three Phase 5kV EFT/Burst GeneratorSwitching the transient process (to cut off inductive load, relay contact bounce, etc.) usually interferes with other electrical and electronic equipment in the same circuit. This type of
-
30kV ESD GunOur company independently develops and manufactures 30kV ESD (electrostatic discharge) generators. The maximum output voltage is up to 30kV. It is mainly used to simulate electrostatic shocks in
-
Three Phase Surge Burst Transient GeneratorMulti-function immunity tester can carry out electrostatic discharge immunity, electrical fast transient/ burst immunity and surge (impact) immunity test. It is multifunctional combination immunity
-
Data Line Coupling NetworksCDN-I/O, CDN-I/OE are designed for communication/telecom products and other signal lines coupling/decoupling surge test network. It can be tested in single, double(1-pair), four(2-pair) and eight
-
10kV Surge GeneratorSurge pulses occur due to direct or indirect lightning strikes or by power system switching transients caused by switching inductive loads or short circuits. This leads to currents or electromagnetic
-
Single Phase 10A Voltage Dips GeneratorVoltage dips/sags, short interruptions are caused by failures of the power grid and power facilities or sudden large changes in loads. In some cases, there will be two or more consecutive dips or
-
Single Phase 20A Voltage Dips GeneratorVoltage dips/sags, short interruptions are caused by failures of the power grid and power facilities or sudden large changes in loads. In some cases, there will be two or more consecutive dips or
-
Single Phase 6kV EFT/Burst GeneratorEFT/burst generator or transient generator or voltage spike generator is used for evaluating the performance of electrical and electronic equipment power supply, signal, control & earth ports when
-
Three Phase 6kV EFT/Burst GeneratorSwitching the transient process (to cut off inductive load, relay contact bounce, etc.) usually interferes with other electrical and electronic equipment in the same circuit. This type of
-
HBM MM ESD Immunity Tester ESD 8KElectrostatic discharge (ESD) is a common natural phenomenon. The ESD 8K is specially designed in accordance with the characteristics and requirements of electrostatic discharge immunity tests for
The EM Test capacitive coupling clamp ACC is used to couple fast transient pulses to I/O lines as required in different national and international standards and car manufacturer specifications for...
The EM Test capacitive coupling clamp ACC is used to couple fast transient pulses to I/O lines as required in different national and international standards and car manufacturer specifications...
Sep 27, 2008 · A capacitive coupling clamp that conforms to requirements of ISO 64000-4-4 is built for measuring the resistance of three different cables (a twisted pair, RG - 58A/U and RG -...
COUPLING OF FAST TRANSIENT PULSES TO I/O LINES The capacitive coupling clamp ACC is used to couple fast transient pulses to I/O lines as required in different national and...
The capacitive coupling clamp by Thermo-Keytek is designed for EFT pulses on I/O lines or data lines per EN/IEC 61000-4-4. This equipment is fully compliant with the specifications of IEC 61000-4-4...
The Capacitive Coupling Clamp, EFTC 2012, provides the ability to couple Burst / EFT pulses to data lines. It can also be used for coupling to main lines where no CDN is available, for example, high...
