-
Capacitive Coupling ClampEFT 4C capacitive coupling clamp is used together with EFT/burst generator. It is used to do EFT/burst interference test of the I/O data signal line port. Its main purpose is coupling the EFT/burst
-
Single Phase 5kV EFT/Burst GeneratorEFT/burst generator or transient generator or voltage spike generator is used for evaluating the performance of electrical and electronic equipment power supply, signal, control & earth ports when
-
Three Phase 5kV EFT/Burst GeneratorSwitching the transient process (to cut off inductive load, relay contact bounce, etc.) usually interferes with other electrical and electronic equipment in the same circuit. This type of
-
Damped Oscillatory Magnetic Field GeneratorDamped oscillatory magnetic fields are generated by the switching of H.V. bus-bars by isolators or disconnectors. The magnetic fields to which equipment subjected can influence the reliable operation
-
1kV Surge GeneratorSurge generator SOSIN 8/20 is designed especially for telecom/communications, digital products and anti-surge semiconductor devices. The open circuit voltage is up to 1000V. Product can fully meet
-
Lightning Surge SimulatorSurge pulses occur due to direct or indirect lightning strikes or by power system switching transients caused by switching inductive loads or short circuits. This leads to currents or electromagnetic
-
Single Phase 10A Voltage Dips GeneratorVoltage dips/sags, short interruptions are caused by failures of the power grid and power facilities or sudden large changes in loads. In some cases, there will be two or more consecutive dips or
-
Three Phase 20A Voltage Dips GeneratorVoltage dips/sags, short interruptions are caused by failures of the power grid and power facilities or sudden large changes in loads. In some cases, there will be two or more consecutive dips or
-
Single Phase 6kV EFT/Burst GeneratorEFT/burst generator or transient generator or voltage spike generator is used for evaluating the performance of electrical and electronic equipment power supply, signal, control & earth ports when
-
Three Phase 6kV EFT/Burst GeneratorSwitching the transient process (to cut off inductive load, relay contact bounce, etc.) usually interferes with other electrical and electronic equipment in the same circuit. This type of
-
Ring Wave Generator RWI S6A ring wave generator is used to evaluate the performance of electrical and electronic equipment, devices or systems subjected to ring wave. Ring wave is caused by power supply and control line
-
HBM MM ESD Immunity Tester ESD 8KElectrostatic discharge (ESD) is a common natural phenomenon. The ESD 8K is specially designed in accordance with the characteristics and requirements of electrostatic discharge immunity tests for
The Capacitive Coupling Clamp, EFTC 2012, provides the ability to couple Burst / EFT pulses to data lines. It can also be used for coupling to main lines where no CDN is available, for example, high...
EFT 4C capacitive coupling clamp is used together with EFT/burst generator. It is used to do EFT/burst interference test of the I/O data signal line port. Its main purpose is coupling the...
EFTs are applied at certain injection points in various methods of EFT testing. For example, in signal/control ports with cable lengths of less than 3 m, the EFT is applied through a capacitive...
A capacitive coupling clamp is used to couple EFT bursts onto data, I/O, and telecommunications lines. Construction of the clamp is shown in Figure 5 of IEC 61000-4-4; however, considerable...
IEC 61000-4-4 Ed.3 defines a transducer plat for calibration of the capacitive coupling clamp. A transducer plate shall be inserted into the coupling clamp, and an adapter VERI50 EFT with a low...
EFT 4C capacitive coupling clamp is used together with EFT/burst generator. It is used to do EFT/burst interference test of the I/O data signal line port. Its main purpose is coupling the EFT/burst...
